Vortex Silver Series Bedienungsanleitung PDF herunterladen (Seite 14)

VORTEX

SILVER SERIES



   

  

 

VORTEX-V8

120/230 V ~ 50/60 Hz 2100 W

4400 W / 2

xxxxx

USER MANUAL

VORTEX SILVER SERIES V8

P.13

WARNING!

SPEAKON connectors marked with the lightning flashes indicate high

voltages that are potentially life threatening.

Wiring to these terminals requires installation by an instructed person or

the use of ready-made leads or cords.

Custom wiring should only be carried out by qualified personnel.

To prevent electric shock, do not operate the amplifier with any of the

conductor portion of the speaker wire exposed.

NOTE: For reasons of safety and performance do only use high-qual-

ity fully insulated speaker cables of stranded copper wire. Use the

largest wire size that is economically and physically practical. Make

sure that the cables are not longer than necessary.

IMPORTANT: When connecting speaker cabinets in parallel, always

use all the contacts in both SPEAKON connectors. If not, this may

cause permanent damage to the connectors and considerably reduce

performance.

3.4 Mains supply

When mounting or connecting the amp, always disconnect it from mains.

Only connect the V8 amplifier to an appropriate AC circuit and outlet in accord-

ance with the requirements indicated in the second line on the rating plate.

Exemplary rating plates for a mains supply of 120/230 V AC 50/60 Hz.

Power Supply Data:

Voltage Mains Frequency Current Power Consumption

120/230 V

50/60 Hz 30/15 A 2100 W

NOTE: Even under normal conditions the mains current can reach lev-

els up to 20 A (230 V), and 40 A (120 V), respectively; this could cause

lamps to flicker if connected to the same mains as the amp. The im-

pedance of the AC circuit should be less than 0,157 Ω to avoid flicker

according to EN61000-3-11 “Electromagnetic compatibility – Part 3-

11: Limits – Limitation of voltage changes, voltage fluctuations, and flicker

in the public low-voltage supply systems – Equipment with rated current ≤

75 A and subject to conditional connection”. If in any doubt, consult your

local power provider. Never attempt to measure this impedance level with

your Ohmmeter. This may damage your meter and expose you to the risk

of electric shock!

3 INSTALLATION

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 29 30

Kommentare zu diesen Handbüchern

Keine Kommentare

Vortex Silver Series Bedienungsanleitung Seite 14

Kommentare zu diesen Handbüchern